Digi Config
m (→Digi Config) |
m |
||
| Line 5: | Line 5: | ||
[[Image:DigiSettings.jpg]] | [[Image:DigiSettings.jpg]] | ||
| + | |||
| + | The relevant serial commands are: | ||
| + | |||
| + | ALIAS <n> <callsign> | ||
| + | Sets digipeater alias for slot <n>, where n is between 1 and 8. This will | ||
| + | typically be a generic alias like ʹWIDEʹ. No SSID is allowed in this field. | ||
| + | |||
| + | DIGI on|off | ||
| + | When enabled, the tracker will digipeat packets having its own callsign | ||
| + | (MYCALL) in the next digipeater address field. | ||
| + | |||
| + | DIGIID <n> on|off | ||
| + | Enables callsign substitution for digipeater alias <n> (1 to 8). This should | ||
| + | normally be enabled. | ||
| + | |||
| + | DUPETIME <0‐255> (seconds) | ||
| + | Sets digipeating duplicate suppression period. | ||
| + | |||
| + | HOPLIMIT <n> <hops> | ||
| + | For digipeater alias <n> (1‐8), sets the maximum number of digipeater | ||
| + | hops allowed. This can be used to limit excessively long paths that may | ||
| + | cause network degradation. | ||
| + | |||
| + | PREEMPT <n> on|off | ||
| + | Enables digipeater preemption for alias <n> (1‐8). If preemption is | ||
| + | enabled, packets will be digipeated on this alias even if it isnʹt the next | ||
| + | address in the packet’s digipeater list. | ||
| + | |||
| + | USEALIAS <n> on|off | ||
| + | Enables digipeating for alias n. | ||
Revision as of 14:57, 9 October 2008
Back to manual[[1]]
Configuring the Digipeater Settings
The relevant serial commands are:
ALIAS <n> <callsign> Sets digipeater alias for slot <n>, where n is between 1 and 8. This will typically be a generic alias like ʹWIDEʹ. No SSID is allowed in this field.
DIGI on|off When enabled, the tracker will digipeat packets having its own callsign (MYCALL) in the next digipeater address field.
DIGIID <n> on|off Enables callsign substitution for digipeater alias <n> (1 to 8). This should normally be enabled.
DUPETIME <0‐255> (seconds) Sets digipeating duplicate suppression period.
HOPLIMIT <n> <hops> For digipeater alias <n> (1‐8), sets the maximum number of digipeater hops allowed. This can be used to limit excessively long paths that may cause network degradation.
PREEMPT <n> on|off Enables digipeater preemption for alias <n> (1‐8). If preemption is enabled, packets will be digipeated on this alias even if it isnʹt the next address in the packet’s digipeater list.
USEALIAS <n> on|off Enables digipeating for alias n.
