Profile Switching

From APRSWiki
(Difference between revisions)
Jump to: navigation, search
(New page: == Profile Switching == '''High APRS Digipeater''' To configure for a high or low digi only, you probably will not need profile switching. Therefore the screen will look like this below...)
 
(Profile Switching)
Line 3: Line 3:
 
'''High APRS Digipeater'''
 
'''High APRS Digipeater'''
  
To configure for a high or low digi only, you probably will not need profile switching.  Therefore the screen will look like this below.
+
To configure for a high or low digi only, you probably will not need profile switching as we normally use it for a trackerUnless of course you want to switch profiles to alert you as to a high or low temperature event or a low voltage situation.  The temperature probe is built into the Tracker2 but there is none in the T2-135.  Normally the screen will look like this below.
 +
 
 
[[Image:ProfileSwitchingHighDigi.jpg]]
 
[[Image:ProfileSwitchingHighDigi.jpg]]

Revision as of 12:28, 27 September 2008

Profile Switching

High APRS Digipeater

To configure for a high or low digi only, you probably will not need profile switching as we normally use it for a tracker. Unless of course you want to switch profiles to alert you as to a high or low temperature event or a low voltage situation. The temperature probe is built into the Tracker2 but there is none in the T2-135. Normally the screen will look like this below.

ProfileSwitchingHighDigi.jpg

Personal tools