Profile Switching
From APRSWiki
(Difference between revisions)
m |
m |
||
| Line 6: | Line 6: | ||
[[Image:ProfileSwitchingHighDigi.jpg]] | [[Image:ProfileSwitchingHighDigi.jpg]] | ||
| + | |||
| + | |||
| + | '''Setup as a Tracker''' | ||
| + | |||
| + | need more info here, some various thoughts on what you might want to switch on. Also comment on KISS and profile switching. | ||
Revision as of 18:44, 27 September 2008
Back to manual[[1]]
High APRS Digipeater
To configure for a high or low digi only, you probably will not need profile switching as we normally use it for a tracker. Unless of course you want to switch profiles to alert you as to a high or low temperature event or a low voltage situation. The temperature probe is built into the Tracker2 but there is none in the T2-135. Normally the screen will look like this below.
Setup as a Tracker
need more info here, some various thoughts on what you might want to switch on. Also comment on KISS and profile switching.
